38 введение in russian groove. the tool self-made

38_ВВЕДЕНИЕ In RUSSIAN GROOVE. THE TOOL SELF-MADE.

While figure, and the material of handles both steel for cutters and chisels has given earlier. Chisels -1, 2, 3 - the Set, and for a groove of Spherical details is necessary till three chisels on a diameter. In the beginning the chisel with Round will suffice
 chisels in width-on 4, 6, 10 is a typical size of elements on a carved board. If you decide(solve) to cut a groove with a Flat background, I level by his(its) Direct chisels of width железки 2 - 4 mm. Figure -4, 5. To a groove Large закруглений –radius-and large radiuses apply a cutter - jamb, that is done(made) of a piece ножовочного steel-of a cloth of the stamp - 40ХНВА or скальпеля – a knife of surgeon-, but then is tiresome in the wooden handle, in половинках To hollow a deepening and to collect the handle, for example on эпоксидном glue. It became possible to make of other stamps both jamb and chisels, but the skilled smith is necessary. It is connected to that that the edge of the tool has a Narrow cutting side. On a cloth from steel-ножовки, agrees of figure it is necessary to remove(take off)
Фаску in width not less than 5 mm. If a cutter Мнет – press- wood, grind off, extend cutting кромку –an edge-on half. On a fragment -12 processes of a groove.
ENGINEERING of a GROOVE.
I резу- cut -кудри –element of groov-or other Spherical elements by a diameter from 6 - 8 mm. On this the chisel with such железкой –an edge dirext- and Straight line cutting кромкой undertakes. The circle is pinned on depth 2 - 3 mm. If is, Larger circles are pinned by chisels on a diameter - 10 mm and more, or прорезаются –cuting- by a jamb as two – гранной -2x 2 mm lines- of a flute. Then by round chisel by a diameter 4 - 6 mm, at will, and presence get out a background, лунками choosing it(him). Length лунок will be fulfilled in due course, for example - cut set of Identical deepenings by a number(line) of length 4 - 6 mm. It is possible such background to leave, or to level by chisels with direct железкой, width 2 - 3 mm. Other long lines кудрей, листьев -elements-are cut by a jamb, and the depth is maximal at radiuses, on the end and at middle ветки a jamb leave on a surface. On this also apply the term - in Russia - FLAT groove, as she, groove заглублена –dept out- from a surface on 2 - 4 mm. Figure - 11 are Versions of a groove, that is Radius of an element, листика – lists- can be срез – cut dept- Steep, or the background still goes deep on as much. It not there is a lot of Version of a groove, and distinctive hand of the foreman! A fragment -10 learn(teach,study) ДОРИСОВЫВАТЬ – paint on- ready figure. From above - elements - листья of Different diameters, and in the bottom of their radius is given approximately to R = 6 mm, on presence of chisels at me. Compare figure master name Ворносков –Vornoskov- - In ДОЗОРЕ – SOLDIERS IN FOREST_, and my board, I am direct on the Unpacked(printed out) figure has lead(carried out) lines by a pencil UNDER ONE SIZE ЛИСТЬЕВ, OR КУДРЕЙ -ELEVENTSS. Has informed master Вл. НеКрылович.